Table of Contents
Advertisement
CONFIGURATION
4-2.1
Setting Target ID
Remove medium changer magazine (if mounted) prior to performing
this procedure.
The following procedure describes the steps required to set the Target ID.
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Step 7.
Step 8.
Step 9.
Step 10.
Step 11.
a. If there is an outstanding SCSI command or if there is a tape loaded in the tape drive then Off-line
mode cannot be entered.
4-2.2
Emergency ROM Load
Step 1.
From a powered-off state, turn power to on while pressing SHIFT + RESET. Release
SHIFT + RESET when SELFTEST is displayed.
4-8
** NOTE **
Press and hold both the TEST and UNLOAD keys, wait for OFFLINE to be displayed
a
then release both keys.
Once the keys are released then the first item, DIAGMODE,
in the main Off-line menu will be displayed. (Keys must be held for approximately 2
seconds before Off-line mode is entered.)
Press the START pushbutton until SETTING is displayed.
Press the TEST pushbutton.
The first option, 70: S.TAR, is displayed. Press TEST to view the setting. The set-
ting may be incremented by pressing START or decremented by pressing SHIFT and
START.
Press TEST to return to 70: S.TAR
Press SHIFT and START until 89: WTROM is displayed.
Press TEST to view settings at option 89: WTROM.
Press START until y is displayed.
Press the TEST pushbutton to write the setting to ROM.
Press TEST to return to 89: WTROM.
Press RESET twice to return to .
CG00000-011403 REV. A
M2488 USER'S GUIDE
April 1997
Advertisement
Table of Contents
