Table of Contents
Advertisement
System Operation
Q9 Plus ASD Install/Op Manual
System Operation
Standard Start Up Wizard
Note:
Do not run the Standard Start Up
Wizard and the VLP Wizard. Running
both will result in an operational conflict
that will require a reset to factory
defaults and a restart using only one
wizard. Reset to the factory default
settings after running either wizard to
run the other wizard.
The Start Up Wizard assists with the initial
configuration of the input power settings and the
output parameters of the Q9 Plus ASD.
The Start Up Wizard is launched from Program
Utilities Standard Start Up Wizard. See the
section titled
Standard Startup Wizard
Requirements on pg. 30
for more information on
launching the wizard.
The Q9 Plus ASD may also be setup via
communications, by accessing the individual
parameters via the menu hierarchy, or by using the
Direct Access
Parameters/Numbers.
See the section titled
Default Setting Changes on
pg. 29
for more information on changing the
parameter settings.
After the initial power up, the wizard may be run on
the next power up operation by setting the following
menu item to Yes — Program Utilities Display
Parameters Display the start up wizard next
power up?
Upon the next power up, the system will launch the
Start Up Wizard. Once completed, the system will
set the Display the start up wizard next power-up?
setting to No (for the next system power up) and
normal start ups will resume.
The Start Up Wizard cannot be used to confirm any
parameter settings. Each time that the wizard is
launched the default settings appear in all write
fields. Any user-written values are recorded and
used by the system. Via direct access, the
individual wizard parameters may be accessed and
viewed to confirm the parameter settings.
The Start Up Wizard querys the user for the
following information:
1. The
Voltage and Frequency Rating of the Motor
(F409/F014).
2. The
Upper-Limit Frequency
3. The
Lower-Limit Frequency
28
4.
5. The
6. The
7. The
8. The
9. The
10.The
11.The
12.The
Click
into the ASD.
See the section titled
Requirements on pg. 30
on the Start Up Wizard.
Operation (Local)
To run the motor perform the following steps:
1. Press the Mode key until the Frequency
2. Press the Local/Remote key to enter the Local
3. Turn the Rotary Encoder clockwise until the
Note:
4. Press the Run key (green Run LED illuminates
Note:
(F012).
5. Press the Stop-Reset key to stop the motor.
(F013).
Automatic Accel/Decel (F000)
continue from step #7).
Acceleration Time
(F009).
Deceleration Time
(F010).
Volts Per Hertz Control Type
Motor Current Rating
Motor Rated Speed
(F407).
Command Source
(F003).
Frequency Command Source
Display Units (F701)
Exit
to load the settings of the Start Up Wizard
Standard Startup Wizard
for additional information
Command screen is displayed.
Frequency Command Screen.
mode (Local LED is illuminated).
Frequency Command value is displayed in the
Set field.
Ensure that there are no personnel
around or near the motor or the motor-
driven equipment.
red) and the motor runs at the Frequency
Command value.
The speed of the motor may be
changed while the motor is running by
using the Rotary Encoder to change
the Frequency Command value.
https://www.toshiba.com/tic/
(if Enabled,
(F015).
(F406).
(F004).
for current and voltage.
Advertisement
Table of Contents
