Toshiba Q9+ Installation & Operation Manual page 125

RX Input Point 1 Setting
RX
Program Frequency Speed Reference Setpoints
This parameter is used to set the gain and bias of the RX input
terminal when the RX terminal is used as the control input while
operating in the Speed Control mode or the Torque Control
mode.
This parameter sets the RX input level that is associated with RX
Input Point 1 Frequency when operating in the Speed Control
mode or is associated with the RX Input Point 1 Rate when oper-
ating in the Torque Control mode.
RX Input Speed Control Setup
Perform the following setup to allow the system to receive Speed
control input at the RX input terminal:
• Program Fundamental Standard Mode Selection 
Frequency Mode 1 RX.
• Program Fundamental Standard Mode Selection 
Command Mode Selection Terminal Board.
Speed Control
Perform the following setup to allow the system to perform Speed
control from the RX input terminal:
• Set RX Input Point 1 Frequency (F217).
• Set RX Input Point 1 Setting (F216) — the input analog signal
level that corresponds to the speed setting at RX Input Point 1
Frequency.
• Set RX Input Point 2 Frequency (F219).
• Set RX Input Point 2 Setting (F218) — the input analog signal
level that corresponds to the speed setting at RX Input Point 2
Frequency.
• Provide a Run command (F and/or R).
Once set, as the RX input voltage changes, the ASD output
speed and/or torque will vary in accordance with the above set-
tings.
This parameter value is entered as -100% to +100% of the RX
input signal range.
See F474
response.
https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
and F475 for information on fine-tuning this terminal
–
F216 F217
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — -100
Maximum — +100
Units — %
Frequency Settings
F216
113