Toshiba Q9+ Installation & Operation Manual page 190

Acceleration/Deceleration Switching Frequency 1
Program Special  ACC/DEC Special
This parameter sets the frequency at which the acceleration con-
trol is switched from the Accel 1 profile to the Accel 2 profile
during a multiple-acceleration profile configuration.
IP Address Setting Method
Program Communications Ethernet Settings
This parameter is used to select the method used to set the IP
address for a network device (ASD).
Selecting Manual at this parameter will require that parameters
F577 – F580 and parameters
create the IP address and Subnet Mask Data, respectively, for
the device.
Selecting BOOTP or DHCP results in the IP address being sup-
plied by the server. See
ting the IP address.
Settings:
0 — Manual
1 — BOOTP
2 — DHCP
IP Card Data 1
Program Communications Ethernet Settings
Selecting Manual at parameter
F580 to be used to create an IP address for the connected
device.
This parameter is used to configure the IP Data Card 1 section of
the IP address of the device.
IP Card Data 1 IP Card Data 2
IP Card Data 2
Program Communications Ethernet Settings
This parameter operates in conjunction with parameter F577.
This parameter is used to configure the IP Data Card 2 section of
the IP address of the device.
See F577 for additional information on this parameter.
178
–
F505
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F582 – F584 be used to manually
F577 for additional information on set-
F576 enables parameters
IP Card Data 4
IP Card Data 3
F579
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
Direct Access Number —
Parameter Type — Selection List
Factory Default — Manual
Changeable During Run — Yes
Direct Access Number —
Parameter Type — Numerical
Factory Default — 00
F577 –
Changeable During Run — Yes
Minimum — 00
Maximum — 255
Direct Access Number —
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
https://www.toshiba.com/tic/
F505
F576
F577
F578