Preset Speed 11
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
1011 and is identified as Preset Speed 11. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See
F018
for additional information on this parameter.
Preset Speed 12
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
1100 and is identified as Preset Speed 12. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See
F018
for additional information on this parameter.
Preset Speed 13
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
1101 and is identified as Preset Speed 13. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See
F018
for additional information on this parameter.
Preset Speed 14
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
1110 and is identified as Preset Speed 14. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See
F018
for additional information on this parameter.
134
–
F290
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F294
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
https://www.toshiba.com/tic/
F290
F291
F292
F293