System Operation; Initial Setup; Operation (Local) - Toshiba H7 Operation Manuals

System Operation

Initial Setup

Upon initial system powerup, the Startup Wizard starts automatically. The Startup Wizard assists the
user with the initial configuration of the input power settings and the output parameters of the H7 ASD.
The ASD may also be setup by directly accessing each of the individual parameters (see the section titled
Direct Access Parameter Information on pg.
The Startup Wizard querys the user for the following information:
1. Run now? (if selected continue on to step #2)/Run next time at power up? (if selected go to
Program Mode)/Manually configure? (if selected go to Finish
2. The Voltage and Frequency rating of the motor.
3. The Upper Limit frequency.
4. The Lower Limit frequency.
5. Adjust Accel/Decel times automatically? (if Yes, continue from step #8).
6. The Acceleration time.
7. The Deceleration Time.
8. The Volts/Hertz setting.
9. The motor Current rating.
10. The Command source.
11. The Frequency Reference source.
See the section titled
Wizard.

Operation (Local)

Note: See F003
To turn the motor on, perform the following:
1. Press the MON/PRG key until the Frequency Command screen is displayed (see
2. Press the Local|Remote key to enter the Local mode (green Local LED illuminates).
3. Turn the Rotary Encoder clockwise until the Frequency Command value is at the desired setting.
4. Press the Run key and the motor runs at the Frequency Command value.
Note: The speed of the motor may be changed while the motor is running by using the Rotary
Encoder to change the Frequency Command value.
5. Press the Stop|Reset key to stop the motor.
Figure 19. Frequency Command screen.
H7 ASD Operation Manual
48).
Startup Wizard Requirements on pg. 27
for information on Remote operation.
⇒ Program Mode).
for additional information on the Startup
Figure 19.).
25