Toshiba Q9+ Installation & Operation Manual page 104

Input Terminal 16 (LI8) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the LI8 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable LI8 termi-
nal to one of the user-selectable functions listed in
page 252.
Note: The Expansion IO Card Option 2 option board (P/N
ETB004Z) is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N
58686) for additional information on the function of this terminal.
Always ON Terminal Function 2
Program Terminal Input Terminals
This parameter is used to set the functionality of the virtual dis-
crete input terminal Always ON Terminal Function 2. As a virtual
terminal, this control terminal exists only in memory and is con-
sidered always to be in its True (connected to CC) state.
It is often practical to assign a function to this terminal that the
user desires to be maintained regardless of external conditions or
operations.
This parameter sets the programmable ON terminal to one of the
user-selectable functions listed in
Always ON Terminal Function 3
Program Terminal Input Terminals
This parameter is used to set the functionality of the virtual dis-
crete input terminal Always ON Terminal Function 3. As a virtual
terminal, this control terminal exists only in memory and is con-
sidered always to be in its True (connected to CC) state.
It is often practical to assign a function to this terminal that the
user desires to be maintained regardless of external conditions or
operations.
This parameter sets the programmable ON terminal to one of the
user-selectable functions listed in
92
–
F126
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Table 9 on
Table 9 on page 252.
Table 9 on page 252.
F130
Direct Access Number —
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number —
Parameter Type — Selection List
Factory Default — (ASD-Depen-
dent)
Changeable During Run — No
Direct Access Number —
Parameter Type — Selection List
Factory Default — (ASD-Depen-
dent)
Changeable During Run — No
https://www.toshiba.com/tic/
F126
F127
F128