Input Function Target 1
Program My Function My Function Unit 5
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the programmable Input
Function Target 1 terminal.
This setting assigns the function of the programmable Input
Function Target 1 terminal to any one of the user-selectable func-
tions listed in
Table 11 on pg.
14 on pg.
260.
See
F977
for additional information on this parameter.
Input Function Command 1
Program My Function My Function Unit 5
This parameter is used to assign a user-selected logical operator
to two user-selected Input Function Target variables, enable a
counter/timer function, or perform a hold/reset function.
Table 15 on pg. 262
lists the available selections. Their use and
selection requirements are described in an example at F977.
Input Function Target 2
Program My Function My Function Unit 5
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the programmable Input
Function Target 2 terminal.
This setting assigns the function of the programmable Input
Function Target 2 terminal to any one of the user-selectable func-
tions listed in
Table 11 on pg.
14 on pg.
260.
See
F977
for additional information on this parameter.
Input Function Command 2
Program My Function My Function Unit 5
This parameter is used to assign a user-selected logical operator
to two user-selected Input Function Target variables, enable a
counter/timer function, or perform a hold/reset function.
Table 15 on pg. 262
lists the available selections. Their use and
selection requirements are described in an example at F977.
238
–
F941
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
256,
Table 12 on pg.
257, or
256,
Table 12 on pg.
257, or
F945
Direct Access Number —
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Table
Direct Access Number —
Parameter Type — Selection List
Factory Default — 0 (NOP)
Changeable During Run — Yes
Direct Access Number —
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Table
Direct Access Number —
Parameter Type — Selection List
Factory Default — 0 (NOP)
Changeable During Run — Yes
https://www.toshiba.com/tic/
F941
F942
F943
F944