Table of Contents
Advertisement
Initial UP/DOWN Frequency Rewriting
Program Frequency UP/DOWN Frequency Functions
At power down, and when enabled, this parameter writes the run-
ning frequency into the
F268
uses this setting as the start up frequency.
Disable this parameter and set parameter
start up frequency if the same starting frequency is required at
each start up.
Note: This parameter setting may be different at each start up
when enabled.
Settings:
0 — Disabled
1 — Enabled
Figure 37. UP/Down Frequency Operation Control Timing Diagram.
https://www.toshiba.com/tic/
–
F269
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
location and, upon a system restart,
F268
to the desired
F270
Direct Access Number —
Parameter Type — Selection List
Factory Default — Enabled
Changeable During Run — Yes
F269
131
Advertisement
Table of Contents
