Toshiba Q9+ Installation & Operation Manual page 109

Input Terminal 13 – 20 Response Time
Program Terminal Input Terminal Delays
This parameter delays the response of the ASD to any change in
the 13 – 20 terminal inputs by the programmed value (see wave-
forms at F140).
The delay may be increased to provide additional electrical noise
immunity or to prevent the ASD from responding to contact
bounce or chatter.
Output Terminal 10 (R3) Function
Program Terminal Output Terminals
This parameter sets the functionality of the R3 output terminal to
any one of the user-selectable functions listed in
page 257.
In addition, the output terminals must be specified as Normally
Open or Normally Closed.
See the instruction manual for the 16-Bit BIN/BCD option for
additional information on the function of this terminal.
Output Terminal 11 (R4) Function
Program Terminal Output Terminals
This parameter sets the functionality of the R4 output terminal to
any one of the user-selectable functions listed in
page 257.
In addition, the output terminals must be specified as Normally
Open or Normally Closed.
See the instruction manual for the 16-Bit BIN/BCD option for
additional information on the function of this terminal.
Base Frequency 2
Program Motor Motor Set 2
The Base Frequency 2 setting is the frequency at which the out-
put voltage of the ASD reaches its maximum setting. The Base
Frequency Voltage 2 parameter is set at F171.
This parameter is used only when the parameters for Motor Set 2
are configured and selected. Motor Set 2 may be selected by a
properly configured input terminal (see
For proper motor operation, the Base Frequency should be set
for the nameplated frequency of the motor.
https://www.toshiba.com/tic/
–
F145
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Table 12 on
Table 12 on
Table 9 on page
F171
Direct Access Number —
Parameter Type — Numerical
Factory Default — 8
Changeable During Run — No
Minimum — 5
Maximum — 200
Units — mS
Direct Access Number —
Parameter Type — Selection List
Factory Default — Always OFF
Changeable During Run — No
Direct Access Number —
Parameter Type — Selection List
Factory Default — Always OFF
Changeable During Run — No
Direct Access Number —
Parameter Type — Numerical
Factory Default — (ASD-Depen-
dent)
Changeable During Run — No
Minimum — (ASD-Dependent)
Maximum — (ASD-Dependent)
252).
Units — Hz
F145
F168
F169
F170
97