Toshiba Q9+ Installation & Operation Manual page 233

Baud Rate Monitor Right Port (Ethernet)
Program Communications Ethernet Settings
This parameter establishes the baud rate detection setting
of the right port.
Settings:
0 — Automatic Detection
1 — 10 Mbps Full
2 — 10 Mbps Half
3 — 100 Mbps Full
4 — 100 Mbps Half
Baud Rate Monitor Left Port (Ethernet)
Program Communications Ethernet Settings
This parameter establishes the baud rate detection setting
of the left port.
Settings:
0 — Automatic Detection
1 — 10 Mbps Full
2 — 10 Mbps Half
3 — 100 Mbps Full
4 — 100 Mbps Half
RS485 Send Delay Time (4-Wire RS485)
Program Communications Communication Settings
This parameter sets the RS485 response delay time.
Changes made to this parameter require that the power be
cycled (off then on) for the changes to take effect.
https://www.toshiba.com/tic/
–
F822
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F826
Direct Access Number —
Parameter Type — Selection List
Factory Default —Automatic Detection
Changeable During Run — Yes
Direct Access Number —
Parameter Type — Selection List
Factory Default —Automatic Detection
Changeable During Run — Yes
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 2.00
Units — Seconds
F822
F823
F825
221