Table of Contents
Advertisement
Device Name Data 6
Program Communications Ethernet Settings
See
F792
for information on this parameter.
Device Name Data 7
Program Communications Ethernet Settings
See
F792
for information on this parameter.
Device Name Data 8
Program Communications Ethernet Settings
See
F792
for information on this parameter.
Baud Rate (2-Wire RS485)
Program Communications Communication Settings
This parameter plays a role in the setup of the communications
network by establishing the Baud Rate of the communications
link.
The communications network includes other ASDs and Host/
Control computers that monitor the status of the ASD(s), trans-
fers commands, and loads or modifies the parameter settings of
the ASD.
Changes made to this parameter require that the power be
cycled (off then on) for the changes to take effect.
Settings:
0 — 9600
1 — 19200
2 — 38400
212
–
F797
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F801
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0000
Changeable During Run — Yes
Minimum — 0000
Maximum — FFFF
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0000
Changeable During Run — Yes
Minimum — 0000
Maximum — FFFF
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0000
Changeable During Run — Yes
Minimum — 0000
Maximum — FFFF
Direct Access Number —
Parameter Type — Selection List
Factory Default — 19200
Changeable During Run — Yes
Units — bps
https://www.toshiba.com/tic/
F797
F798
F799
F800
Advertisement
Table of Contents
