Toshiba Q9+ Installation & Operation Manual page 175

Power Running Torque Limit 1
Program Torque Torque Limit Settings
This parameter determines the source of the control signal for the
positive torque limit setting.
If F441 is selected, the value set at
Running Torque Limit 1 input.
Settings:
1 — V/I
2 — RR
3 — RX
4 — F441 (Setting)
Power Running Torque Limit 1 Level
Program Torque Torque Limit Settings
This parameter provides a value for the Power Running Torque
Limit 1 setting if F441 is selected at parameter F440.
This value provides the positive torque upper limit for the 1 motor.
Regenerative Braking Torque Limit 1
Program  Torque Torque Limit Settings
This parameter determines the source of the Regenerative
Torque Limit control signal.
If F443 is selected, the value set at
ative Torque Limit setting.
Settings:
1 — V/I
2 — RR
3 — RX
4 — F443 (Setting)
Regenerative Braking Torque Limit 1 Level
Program Torque Torque Limit Settings
This parameter provides a value to be used as the Regeneration
Torque Limit 1 if F443 is selected at parameter F442.
Set this parameter to 250% to disable this function.
https://www.toshiba.com/tic/
–
F440
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F441 is used as the Power
F443 is used as the Regener-
F450
Direct Access Number —
Parameter Type — Selection List
Factory Default
Changeable During Run — Yes
Direct Access Number —
Parameter Type — Numerical
Factory Default — 250.00 (Dis-
abled)
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.00 (Disabled)
Units — %
Direct Access Number —
Parameter Type — Selection List
Factory Default —
Changeable During Run — Yes
Direct Access Number —
Parameter Type — Numerical
Factory Default — 250.0 (Dis-
abled)
Changeable During Run — Yes
Minimum — 0.0
Maximum — 250.0
Units — %
F440
—F441 (Setting)
F441
F442
F443 Setting
F443
163