Table of Contents
Advertisement
Safety Information and Precautions
Q9 Plus ASD Install/Op Manual
Qualified Personnel
Installation, operation, and maintenance shall be
performed by Qualified Personnel Only. A Qualified
Person is one that has the skills and knowledge
relating to the construction, installation, operation,
and maintenance of the electrical equipment and
has received safety training on the hazards involved
(refer to the latest edition of NFPA 70E for additional
safety requirements).
Qualified Personnel shall:
• Have carefully read the entire operation manual.
• Be familiar with the construction and function of
the ASD, the equipment being driven, and the
hazards involved.
• Be able to recognize and properly address
hazards associated with the application of motor-
driven equipment.
• Be trained and authorized to safely energize, de-
energize, ground, lock-out/tag-out circuits and
equipment, and clear faults in accordance with
established safety practices.
• Be trained in the proper care and use of
protective equipment such as safety shoes,
rubber gloves, hard hats, safety glasses, face
shields, flash clothing, etc., in accordance with
established safety practices.
For further information on workplace safety visit
www.osha.gov.
Equipment Inspection
• Upon receipt of the equipment, inspect the
packaging and equipment for shipping damage.
• Carefully unpack the equipment and check for
damaged parts, missing parts, or concealed
damage that may have occurred during shipping.
If any discrepancies are discovered, it should be
noted with the carrier prior to accepting the
shipment, if possible. File a claim with the carrier
if necessary and immediately notify the TIC
Customer Support Center.
2
• DO NOT install the ASD if it is damaged or if it is
missing any component(s).
• Ensure that the rated capacity and the model
number specified on the nameplate conform to
the order specifications.
• Modification of this equipment is dangerous and
is to be performed by factory trained personnel.
When modifications are required, contact the TIC
Customer Support Center.
• Inspections may be required after moving the
equipment.
• Contact the TIC Customer Support Center to
report discrepancies or for assistance if required.
Handling and Storage
• Use proper lifting techniques when moving the
ASD; including properly sizing up the load,
getting assistance, and using a forklift if required.
• Store in a well-ventilated location and preferably
in the original carton if the equipment will not be
used upon receipt.
• Store in a cool, clean, and dry location. Avoid
storage locations with extreme temperatures,
rapid temperature changes, high humidity,
moisture, dust, corrosive gases, or metal
particles.
• The storage temperature range of the Q9 Plus
ASD is -13° to 149° F (-25° to 65° C).
• DO NOT store the unit in places that are exposed
to outside weather conditions (i.e., wind, rain,
snow, etc.).
• Store in an upright position.
Disposal
Never dispose of electrical components via
incineration. Contact your state environmental
agency for details on disposal of electrical
components and packaging in your area.
https://www.toshiba.com/tic/
Advertisement
Table of Contents
