Table of Contents
Advertisement
Input Function Target 3
Program My Function My Function Unit 1
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the programmable Input
Function Target 3 terminal.
This setting assigns the function of the programmable Input
Function Target 3 terminal to any one of the user-selectable func-
tions listed in
Table 11 on pg.
14 on pg.
260.
See
F977
for additional information on this parameter.
Output Function Assigned
Program My Function My Function Unit 1
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the Output Function
Assigned terminal.
This setting assigns the function of the programmable Output
Function Assigned data location to one of the functions listed in
the Input Setting field of
Settings:
0 – 3099
See the My Function Instruction Manual (P/N E6581335) and
F977
for additional information on this parameter.
Input Function Target 1
Program My Function My Function Unit 2
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the programmable Input
Function Target 1 terminal.
This setting assigns the function of the programmable Input
Function Target 1 terminal to any one of the user-selectable func-
tions listed in
Table 11 on pg.
14 on pg.
260.
See
F977
for additional information on this parameter.
Input Function Command 1
Program My Function My Function Unit 2
This parameter is used to assign a user-selected logical operator
to two user-selected Input Function Target variables, enable a
counter/timer function, or perform a hold/reset function.
Table 15 on pg. 262
lists the available selections. Their use and
selection requirements are described in an example at F977.
https://www.toshiba.com/tic/
–
F904
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
256,
Table 12 on pg.
257, or
Table 11 on pg.
256.
256,
Table 12 on pg.
257, or
F908
Direct Access Number —
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — No
Table
Direct Access Number —
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — No
Direct Access Number —
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — No
Table
Direct Access Number —
Parameter Type — Selection List
Factory Default — 0 (NOP)
Changeable During Run — No
F904
F905
F906
F907
229
Advertisement
Table of Contents
