Table of Contents
Advertisement
Input Terminal 7 (S3) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the S3 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This parameter sets the programmable S3 terminal to one of the
user-selectable functions listed in
Input Terminal 8 (S4) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the S4 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This parameter sets the programmable S4 terminal to one of the
user-selectable functions listed in
Input Terminal 9 (LI1) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the LI1 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable LI1 termi-
nal to one of the user-selectable functions listed in
page
252.
Note: The Expansion IO Card Option 1 option board (P/N
ETB003Z) is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N
58685) for additional information on the function of this terminal.
https://www.toshiba.com/tic/
–
F117
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Table 9 on page
252.
Table 9 on page
252.
Table 9 on
F120
Direct Access Number —
Parameter Type — Selection List
Factory Default — Damper Feed-
back
Changeable During Run — No
Direct Access Number —
Parameter Type — Selection List
Factory Default — Emergency Off
Changeable During Run — No
Direct Access Number —
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
F117
F118
F119
89
Advertisement
Table of Contents
