Toshiba Q9+ Installation & Operation Manual page 107

Output Terminal 7 (OUT5) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT5 dis-
crete output terminal.
In addition, this output terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable OUT5 ter-
minal to one of the user-selectable functions listed in
page 257.
Note: The Expansion IO Card Option 2 option board (P/N
ETB004Z) is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N
58686) for additional information on the function of this terminal.
Output Terminal 8 (OUT6) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT6 dis-
crete output terminal.
In addition, this output terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable OUT6 ter-
minal to one of the user-selectable functions listed in
page 257.
Note: The Expansion IO Card Option 2 option board (P/N
ETB004Z) is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N
58686) for additional information on the function of this terminal.
Output Terminal 9 (R2) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the R2 discrete
output terminal.
In addition, this output terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable R2 termi-
nal to one of the user-selectable functions listed in
page 257.
Note: The Expansion IO Card Option 2 option board (P/N
ETB004Z) is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N
58686) for additional information on the function of this terminal.
https://www.toshiba.com/tic/
–
F136
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Table 12 on
F140
Direct Access Number —
Parameter Type — Selection List
Factory Default — Always Off
Changeable During Run — No
Table 12 on
Direct Access Number —
Parameter Type — Selection List
Factory Default — Always Off
Changeable During Run — No
Table 12 on
Direct Access Number —
Parameter Type — Selection List
Factory Default — Always Off
Changeable During Run — No
F136
F137
F138
95