Toshiba Q9+ Installation & Operation Manual page 106

Output Terminal 4 (OUT3) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT3 dis-
crete output terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable OUT3 ter-
minal to one of the user-selectable functions listed in
page 257.
Note: The Expansion IO Card Option 1 option board (P/N
ETB003Z) is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N
58685) for additional information on the function of this terminal.
Output Terminal 5 (OUT4) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT4 dis-
crete output terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable OUT4 ter-
minal to one of the user-selectable functions listed in
page 257.
Note: The Expansion IO Card Option 1 option board (P/N
ETB003Z) is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N
58685) for additional information on the function of this terminal.
Output Terminal 6 (R1) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the R1 discrete
output terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable R1 termi-
nal to one of the user-selectable functions listed in
page 257.
Note: The Expansion IO Card Option 1 option board (P/N
ETB003Z) is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N
58685) for additional information on the function of this terminal.
94
–
F133
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Table 12 on
F136
Direct Access Number —
Parameter Type — Selection List
Factory Default — Always OFF
Changeable During Run — No
Table 12 on
Direct Access Number —
Parameter Type — Selection List
Factory Default — Always OFF
Changeable During Run — No
Table 12 on
Direct Access Number —
Parameter Type — Selection List
Factory Default — Always OFF
Changeable During Run — No
https://www.toshiba.com/tic/
F133
F134
F135