Toshiba Q9+ Installation & Operation Manual page 140

Jog Stop Pattern
Program Frequency Jog Settings
This parameter sets the stopping method used while operating in
the Jog mode.
Note: This parameter setting is used for the Jog operation only.
The Emergency Off stopping method setting of parameter
F603 has priority over this setting and changes made here
do not affect the function or setting of parameter
Settings:
0 — Deceleration
1 — Coast
2 — DC Injection
EOI Keypad Operation Jog Mode
Program Frequency Jog Settings
This parameter enables the Jog command to be received from
the EOI. When disabled, the Jog command received from the
EOI is ignored.
Jog commands may also be received from the Terminal Board.
Priority as to which is allowed to override the other is selected at
F106.
The priority selection at
control and disables the other. The
F262 parameter setting.
Settings:
0 — Disabled
1 — Enabled
128
–
F261
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F106 enables the selected source for Jog
F106 setting overrides the
F264
Direct Access Number —
Parameter Type — Selection List
Factory Default — Deceleration
Changeable During Run — No
.
F603
Direct Access Number —
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — Yes
https://www.toshiba.com/tic/
F261
F262