Table of Contents
Advertisement
Virtual Linear Pump Low Start/Stop Point
Program Virtual Linear Pump Start and Stop Points
During a properly configured Virtual Linear Pump operation while
in the On Forward or On Reverse modes (F385), this parameter
establishes the lower level of the Auto Start-Stop threshold.
See
F385
for additional information on this parameter.
The unit of measure for this parameter may be one of the follow-
ing types — the type is selected while running the Virtual Linear
Pump Setup Wizard.
•
PSI
•
GPM
•
Inches of Water Column
•
Feet of Water Column
•
CFM
•
°C
•
°F
•
Custom
(Custom selection allows for three character spaces to be popu-
lated from the 26 alphabet and 13 special characters)
Virtual Linear Pump High Start/Stop Point
Virtual Linear Pump Start and Stop Points
During a properly configured Virtual Linear Pump operation while
in the On Forward or On Reverse modes (F385), this parameter
establishes the upper level of the Auto Start-Stop threshold.
See
F385
for additional information on this parameter.
The unit of measure for this parameter may be one of the follow-
ing types — the type is selected while running the Virtual Linear
Pump Setup Wizard.
•
PSI
•
GPM
•
Inches of Water Column
•
Feet of Water Column
•
CFM
•
°C
•
°F
•
*Custom
Note: *Custom selection allows for three character spaces to be
populated from the 26 alphabet and 13 special characters.
https://www.toshiba.com/tic/
–
F388
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F390
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum —
Maximum —
Units — Selectable at Wizard
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum —
Maximum —
Units — Selectable at Wizard
F388
F403
Setting
F393
Setting
F389
F403
Setting
F393
Setting
153
Advertisement
Table of Contents
