Toshiba Q9+ Installation & Operation Manual page 108

Adjustable speed drives
Table of Contents

Advertisement

Input Terminal 1 (F) Response Time
Program Terminal Input Terminal Delays
This parameter delays the response of the ASD to any change in
the F terminal input by the programmed value.
The delay may be increased to provide additional electrical noise
immunity or to prevent the ASD from responding to contact
bounce or chatter.
Input Terminal 2 (R) Response Time
Program Terminal Input Terminal Delays
This parameter delays the response of the ASD to any change in
the R terminal input by the programmed value (see waveforms at
F140).
The delay may be increased to provide additional electrical noise
immunity or to prevent the ASD from responding to contact
bounce or chatter.
Input Terminal 4 (RES) Response Time
Program Terminal Input Terminal Delays
This parameter delays the response of the ASD to any change in
the RES terminal input by the programmed value (see wave-
forms at F140).
The delay may be increased to provide additional electrical noise
immunity or to prevent the ASD from responding to contact
bounce or chatter.
Input Terminal 5 – 12 Response Time
Program Terminal Input Terminal Delays
This parameter delays the response of the ASD to any change in
the 5 – 12 terminal inputs by the programmed value (see wave-
forms at F140).
The delay may be increased to provide additional electrical noise
immunity or to prevent the ASD from responding to contact
bounce or chatter.
96
F140
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F145
Direct Access Number —
Parameter Type — Numerical
Factory Default — 8
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
Direct Access Number —
Parameter Type — Numerical
Factory Default — 8
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
Direct Access Number —
Parameter Type — Numerical
Factory Default — 8
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
Direct Access Number —
Parameter Type — Numerical
Factory Default — 8
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
https://www.toshiba.com/tic/
F140
F141
F143
F144

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dn-68249-003

Table of Contents