Virtual Input Terminal Selection 3
Program Terminal Input Terminals
This parameter is used to set the functionality of the Virtual Input
Terminal 3. As a virtual terminal, it exists only in memory and is
considered always to be in its True (connected to CC) state.
It is often practical to assign a function to this terminal that the
user desires to be maintained regardless of external conditions or
operations.
This parameter sets the programmable Virtual Input Terminal 3
terminal to one of the functions that are listed in
page
252.
In addition, the input terminal must be specified as Normally
Open or Normally Closed.
Virtual Input Terminal Selection 4
Program Terminal Input Terminals
This parameter is used to set the functionality of the Virtual Input
Terminal 4. As a virtual terminal, it exists only in memory and is
considered always to be in its True (connected to CC) state.
It is often practical to assign a function to this terminal that the
user desires to be maintained regardless of external conditions or
operations.
This parameter sets the programmable Virtual Input Terminal 4
terminal to one of the functions that are listed in
page
252.
In addition, the input terminal must be specified as Normally
Open or Normally Closed.
248
–
F975
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Table 9 on
Table 9 on
F977
Direct Access Number —
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number —
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
https://www.toshiba.com/tic/
F975
F976