Toshiba Q9+ Installation & Operation Manual page 145

Jump Frequency 3
Program Special Jump Frequencies
This parameter is the same as Jump Frequency 1
used when multiple frequencies are to be jumped (see the plus-
or-minus value setting at F275).
When multiple jump frequencies overlap, the system will recog-
nize the lowest and the highest frequencies as one jump range.
Jump Frequency 3 Bandwidth
Program Special Jump Frequencies
This parameter establishes a plus-or-minus value for Jump Fre-
quency 3 (F274).
Preset Speed 8
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
1000 and is identified as Preset Speed 8. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Preset Speed 9
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
1001 and is identified as Preset Speed 9. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Preset Speed 10
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
1010 and is identified as Preset Speed 10. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
https://www.toshiba.com/tic/
–
F274
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
(F270)
F290
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
and is
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — (ASD-Dependent)
Units — Hz
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
F274
F275
F287
F288
F289
133