Toshiba Q9+ Installation & Operation Manual page 231

Command Selection (Modbus+)
Program Communications Modbus Settings
This parameter sets the command function to Prohibit or
Permit.
Settings:
0 — Prohibit
1 — Permit
Number of Command (Modbus+)
Program Communications Modbus Settings
This parameter is used to assign commands.
Settings:
0 — Prohibit
1 — Permit
Number of Monitors (Modbus+)
Program Communications Modbus Settings
This parameter is used to assign monitors.
Command Station (Modbus+)
Program Communications Modbus Settings
This parameter is used to assign the command station.
Baud Rate (4-Wire RS485)
Program Communications Communication Settings
This parameter sets the RS485 baud rate.
Changes made to this parameter require that the power be
cycled (off then on) for the changes to take effect.
Settings:
0 — 9600 bps
1 — 19200 bps
2 — 38400 bps
https://www.toshiba.com/tic/
–
F816
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F821
Direct Access Number —
Parameter Type — Selection List
Factory Default — Prohibit
Changeable During Run — Yes
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 8
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 8
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 64
Direct Access Number —
Parameter Type — Selection List
Factory Default — 19200
Changeable During Run — Yes
F816
F817
F818
F819
F820
219