Textron Jacobsen InCommand PGM 22 Technical/Repair Manual page 64

POWER TRAIN
Installation
See Figures 5-11 through 5-16.
Required Materials
®
• Loctite Primer
®
• Loctite 518 Gasket Eliminator
®
• Loctite 242 (Blue) Thread Sealant
• Anti-Seize Compound
1
5
1. Clean the chain cover (2) and chain case (1) mating
surfaces.
®
2. Apply Loctite Primer to the cover and chain case
mating surfaces.
3. Apply a 1/4 inch (6 mm) bead of Loctite
Eliminator to the chain case mating surface.
3 4
5-8
2
Figure 5-11
®
518 Gasket
7
5 6
Figure 5-12
NOTE
®
Apply Loctite
of the socket-head screws (3 and 5) before installation.
4. Install the cover (7) on the chain case using five
1/4-20 x 1-1/2" socket-head screws (5) and washers
(6).
5. Install three 1/4-20 x 2-1/4" socket-head screws (3)
and washers (4).
8
TN0042
NOTE
Always replace O-rings before assembly.
6. Apply lithium grease NLGI Grade 2 to the reel clutch
lever shaft (8) and O-ring (9) before installation.
10 11
5 6
17
7. Install reel clutch lever (12) in cover (16), using screw
(10), lock washer (11), and retainer (17).
TN0041
242 (Blue) Thread Sealant to the threads
9
Figure 5-13
12
16
Figure 5-14
4157082 First Edition
TN0086
13 14 15
TN0031