Mechanical Troubleshooting - Textron Jacobsen InCommand PGM 22 Technical/Repair Manual

CUTTING UNIT

Mechanical Troubleshooting

Cutting Unit
Condition
Reel drive does not engage when
Operator Presence Control (OPC) bail is
engaged.
8
8-12
Probable Cause
Throttle/clutch cable is not adjusted
properly.
Reel clutch is not engaged.
Traction/reel drive clutch faulty.
PTO-to-reel chain damaged.
Reel clutch damaged.
Remedy
Adjust throttle/clutch cable. (See "Throttle
and Clutch Control Cable Adjustment"
on page 3-4.)
Engage reel clutch. (Refer to Operator's
Manual.)
Replace clutch. (See "Engine and Clutch"
on page 3-7.)
Replace PTO-to-reel chain. (See "Drive
Chains" on page 5-9.)
Replace reel clutch. (See "Traction/Reel
Drive Clutch" on page 5-5.)
4157082 First Edition