Table of Contents
Advertisement
Utilities Options
Maintenance Submenu
Clean Drive — Enables running an installed cleaning cartridge. (Cleaning Slot
must also be enabled in the Setup Menu.)
Park — Enables moving the shuttle assembly to the home position. This option
must be executed before the loader is prepared for transport by insering the Locking
Pin. (See chapter 2, Installation on how to remove and install the Lockin Pin.)
Save Config — Saves all configuration modifications.
Flash Loader — Enables the loader to accept FLASH data through the serial port.
Note:
Not used for firmware upgrade via SCSI.
Download Config — Downloads all configuration modifications.
Note: The use of the Save- and Download Config and the Flash Loader options
requires that the operator has access to the LibCenter utility program.
Set Defaults — Stores the default settings for all setup options in Novram.
Pass Thru — Connects drive serial port to loader serial port allowing direct pass
through. Baud rate is fixed at 19,200.
Reboot Module — Performs a soft reboot of the loader without affecting the
drive.
Diagnostics Submenu
This submenu is used by Technical Support Engineers to perform the following
diagnostic tests:
System Cycle — Cycles cartridges through random slots and the drive.
The magazine must be stocked with a minimum of two and a maximum of seven
(six if the cleaning slot is enabled) cartridges to run this test.
Drive Test — Loads a cartridge into the drive and runs a drive Standalone
Diagnostic test. The magazine must be stocked with at least one writeable cartridge
to run this test.
Cartridge Cycle — Cycles cartridges through random slots in the magazine only.
The magazine must be stocked with a minimum of one and a maximum of seven
(six if the cleaning slot is enabled) cartridges to run this test.
Tandberg SLR Autoloader Service and Repair Manual
46
Advertisement
Table of Contents
