Eri Timeout - Datalogic Magellan 9300i Product Reference Manual

ERI Timeout

Specifies the amount of time that an ERI signal is held in its active state for a
good read.
To set the ERI Timeout:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code,
cover any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the
that represent the desired duration. The selectable range is 1-255, which
is the duration in 10-millisecond increments. Pad all single and double
digit numbers with leading zeros to yield a three-digit entry (001-255).
Examples:
4. The scanner will automatically exit Programming Mode when the appro-
priate amount of digits have been scanned.
DEFAULT
Product Reference Guide
Set ERI Timeout on page 201
000 = ERI timeout disabled
001 = 10ms
005 = 50ms
040 = 400ms
250 = 2,500ms (2.5 seconds)
A setting of 0 (000) disables this feature.
NOTE
Enter/Exit Programming Mode
below. You'll need to
Keypad on page 461
00FA(CR)
Set ERI Timeout
Default setting for this feature is:
002 -20ms
in Appendix C
201