Eri Timeout - Datalogic Magellan 3200VSi Product Reference Manual

General Features

ERI Timeout

Specifies the amount of time the External Read Indicator (ERI) signal is held active for a good
read.
START / END
Sets the ERI timeout duration using hex values from 000 to 255 in increments of ten milliseconds (10ms or 0.01 seconds). To config-
ure this feature, scan the "START/END" bar code above to place the unit in Programming Mode, then the "Set ERI Timeout," followed
by the two digits (zero padded) from the Alphanumeric table in
value. Exit programming mode by scanning the "START/END" bar code again.
24
PROGRAMMING bar codes
DEFAULT SETTING FOR THIS FEATURE: 20 milliseconds (02)
Appendix C, Alpha-Numeric Pad
Set ERI Timeout
representing the desired time
Magellan TM 3200VSi