Update Firmware - Digi ConnectPort LTS Series User Manual

Configure the device using the ConnectPort LTS web interface
Example:
#> backup from=10.0.0.1:config.rci

Update Firmware

To update the firmware for a ConnectPort LTS device, choose one of the following options:
Updated the firmware from Administration > Update Firmware page in the
n
Update the firmware from the command-line interface via TFTP or BOOTP.
n
Digi recommends downloading the firmware to a local hard drive before upgrading the firmware.
Update the firmware from the web interface
Before you update the firmware from the web interface:
1. Download the latest firmware from http://www.digi.com/support.
2. Read the release notes to determine if there are any special steps to complete before
updating the firmware.
To update the firmware from the web interface:
1. Sign in to the web
2. Click Administration > Update Firmware. The Update Firmware page appears.
3. Click Choose File to locate and select the firmware file.
4. Click Update.
Important
appears.
Update the firmware from the command-line interface on a TFTP or BOOTP server
Before you update the firmware from the web interface:
1. Download the latest firmware from http://www.digi.com/support.
2. Read the release notes to determine if there are any special steps to complete before
updating the firmware.
3. Ensure the TFTP or BOOTP server is running before you start this task.
To update the firmware from a TFTP or BOOTP server:
From the command-line interface on a TFTP or BOOTP server, issue the following command:
n
boot load= host ip address :loadfile
See the description of the boot command in the ConnectPort LTS Command Reference for more
information.
Digi ConnectPort LTS User Guide
interface.
DO NOT close the browser until the update is complete and a reboot prompt
Administration
web interface.
123