Dräger Babylog 8000 plus Instructions For Use Manual page 61

2 Set the following ventilation parameters and
press the OK key. Make sure that the results
conform to the values in the following table.
Parameter Setting
Ventilation IPPV
mode
Pinsp 20
Insp. Flow
10
T 0.4
I
T 0.6
E
PEEP/CPAP 0
PEEP/CPAP 10
Checking the apnea alarm
 Set the CPAP ventilation mode.
After a maximum of 30 seconds the alarm
message Apnoea is displayed and the alarm
signal sounds.
Checking the alarm for minute volume
1 Set the IPPV/IMV ventilation mode.
2 Set the MV alarm limit: 1 L/min
After a maximum of 30 seconds the alarm
message MV low is displayed and the alarm signal
sounds.
3 Set the MV and MV
desired values.
Instructions for use Babylog 8000 plus SW 5.n
Checking the alarm for airway pressure
1 Kink the expiratory breathing hose.
The alarm signal sounds and one of the following
Result in Paw
alarm messages is displayed:
bar display
– Airway pressure high
-
– Hose kinked?
Inspiratory:
(20 ±4) mbar
Ventilation is interrupted and the bar display shows
Ventilation corre-
an airway pressure of <5 mbar. After
sponds with the
approx. 5 seconds, ventilation is continued and
set ratio of T and
immediately interrupted again. The procedure
I
T .
repeats.
E
Expiratory:
2 Release the expiratory breathing hose.
(0 ±2) mbar
3 Disconnect the connector on the Y-piece.
Expiratory:
After a maximum of 15 seconds the alarm signal
(10 ±2) mbar
sounds and one of the following alarm messages
is displayed:
– Airway pressure low
– Leak in hose system?
The bar display shows an airway pressure of
≤ 4 mbar.
4 Set the PEEP/CPAP setting knob back to 0.
5 Reconnect the Y-piece.
Checking the speaker and LEDs
The speaker and LEDs can also be checked while
the device is in operation.
alarm limits to the
 Press and hold the OK key for
All LEDs light up and a continuous tone sounds as
long as the key is pressed.
Inspiration cancelled
Check setting!
approx. 2 seconds.
Getting started
61