Dräger Babylog 8000 plus Instructions For Use Manual page 101

Selecting the language
The device is factory set to the customer's
language.
1 Open the dialog window by pressing the Cal.
Config. > Config > Lang keys.
The selected language is highlighted.
Configuring the data interfaces
The following data interfaces can be configured:
– Analog output ports
– Impulse output
– RS232
This setting is saved after the device is switched
off.
Selecting the measuring signals and
scale range for the analog output ports
1 Open the dialog window by pressing the Cal.
Config. > Config > Com keys.
2 Press the Param key repeatedly until Analog1
is highlighted.
3 Use the and
measuring signal.
Instructions for use Babylog 8000 plus SW 5.n
keys to select the
2 Use the and
language.
This setting is saved after the device is switched
off.
4 Press the Param key.
5 Use the and
scale value.
Select the settings for Analog2 in the same way.
Configuration
keys to select the
keys to select the
101