Dräger Babylog 8000 plus Instructions For Use Manual page 40

Assembly and preparation
Parking the trolley
CAUTION
Risk of patient injury
If the brakes are not locked, the trolley may move
unintentionally on inclined surfaces, thereby
endangering the patient.
Lock all brakes on the trolley and check the brake
function during stationary operation.
Mounting an additional monitor
CAUTION
Incorrectly transferred data
All transferred data is for informational purposes
only and must not be used as basis for diagnostic
or therapeutic decisions.
Check the displays on Babylog 8000. The
MEDIBUS interface is not intended for use with a
"distributed alarm system" according to
IEC 60601-1-8:2012.
Information on mounting
Monitors can be mounted on the ventilator using
the appropriate holder.
WARNING
Risk of tipping over
If a monitor is mounted on the ventilator,
there is a risk of the device tipping over.
Combining devices is only approved on the
trolley. The counterweight must be mounted
under the base plate of the trolley.
40
Parking the trolley for stationary operation:
1 Lock all brakes on the trolley.
2 Check the brake function.
Graphic Screen
The Graphic Screen option and VentView software
allow ventilation parameters to be displayed both
graphically and numerically.
The touch screen is provided with the Graphic
Screen option.
Data connection
A suitable data cable must be used to establish a
data connection between Babylog 8000 and
Graphic Screen. The data cable is connected to
the COM port (RS232 interface).
It is also possible to connect Graphic Screen to
another PC using another data cable, e.g., in order
to archive data. For additional information, see the
"Graphic Screen option" instructions for use.
Instructions for use Babylog 8000 plus SW 5.n