Dräger Babylog 8000 plus Instructions For Use Manual page 45

Attaching and removing the breathing hoses
 When attaching and removing the breathing
hoses, always hold them at the connection
sleeve and not at the coil reinforcement.
Attaching the breathing hoses when no
incubator is being used
1 Place the clamp of the hinged arm on the
lateral standard rail of the trolley and tighten
the screws. Depending on the position of the
device relative to the bed, the hinged arm can
be fitted to the left or right side.
2 Rotate the inspiratory and expiratory ports
down or in the direction of the patient.
Instructions for use Babylog 8000 plus SW 5.n
3 Connect the breathing hoses to the inspiratory
and expiratory ports. Observe the hose
lengths.
4 Install the water trap and place it vertically.
Attaching the breathing hoses when being
used on the Dräger Incubator 8000 or Caleo
1 Connect the breathing hoses to the inspiratory
and expiratory ports. Observe the hose
lengths.
2 Install the water trap and place it vertically.
3 Mount the holder for breathing hoses in the
incubator.
4 Press the rubber connection sleeves on the
breathing hoses into the clamp on the holder.
Assembly and preparation
45