Dräger Babylog 8000 plus Instructions For Use Manual page 100

Configuration
Setting the volume of the alarm signal
WARNING
Missing alarm signals in loud environments
Alarm situations are not recognized.
Set the volume of the alarm signals so that
they can be heard.
Setting the screen contrast
This setting can only be made on devices with LC
screens.
This setting is saved after the device is switched
off.
1 Open the dialog window by pressing the Cal.
Config. > Config > Contr keys.
A test pattern is displayed.
2 Reduce the contrast by pressing the
3 Increase the contrast by pressing the
100
This setting is saved after the device is switched
off.
1 Open the dialog window by pressing the Cal.
Config. > Config >
2 Reduce the volume by pressing the
3 Increase the volume by pressing the
A test tone at the respective volume sounds as the
volume is increased stepwise.
key.
key.
Instructions for use Babylog 8000 plus SW 5.n
keys.
key.
key.