Port; Ethernet (Lan) Port; Usb Connector - Lightware MX2-8x8-DH-4DPio-A User Manual

   
4. Installation
4.2.4. RS-232 Port
3-pole Phoenix Connector

DIFFERENCE: Certain models are supplied with 3-pole Phoenix connector for RS-232 communication.
Compatible Plug Type
Phoenix Combicon series (3.5mm pitch, 3-pole), type: MC 1.5/3-ST-3.5.
®
D-SUB Connector
DIFFERENCE:
The -R suffixed models have female D-SUB connector for RS-232 data communication.
INFO:
MX2-HDMI20 series matrix switchers are DCE units according to their pin-out. For more information,
see the Serial Management section.
Factory default settings of the serial port: RS-232 enabled; 57600 Baud, Protocol: LW3.
MX2 Standalone Matrix Switcher series – User's Manual
4.2.5. Ethernet (LAN) Port
The matrix can be controlled by Ethernet/LAN connection. The Ethernet port can be connected to a LAN hub,
switch or router by a CATx cable. While both cable types (straight or cross) are supported and handled by the
device, the pin assingment below is recommended.
RJ-45 Connector

DIFFERENCE:
details in the
Neutrik EtherCON Connector

DIFFERENCE:
communication.
4.2.6. USB Connector
MX2-HDMI20 series matrix switchers have standard USB mini-B receptacle.
Applied firmware package: v1.9.0 | LDC software: v2.6.2b3
Certain models are supplied with RJ45 connector for Ethernet communication. See the
Model Comparison table.
LED 1, Amber LED 2, Green
OFF 10 Mbps No link
Blinking N/A Activity
ON 100 Mbps Link is active
The -R suffixed models have EtherCON connector for Ethernet
33