Electrical Connections; Hdmi Input And Output Ports; Analog Audio Inputs And Outputs; Port - Lightware MMX6x2-HT200 User Manual


  
3. Product Overview
3.3. Electrical Connections
3.3.1. HDMI Input and Output Ports
The matrix switchers are assembled with standard
19-pole HDMI connectors for inputs and outputs.
3.3.2. Analog Audio Inputs and Outputs
5-pole Phoenix connector is used for balanced analog
audio (line in/out). Some I/O boards use this connector
as a configurable input or output. Unbalanced audio
signals can be connected as well. For asymmetrical
output, connect only + and ground. For asymmetrical
input connect + and ground to the source and connect
– to the ground.
Compatible Plug Type
Phoenix Combicon series (3.5mm pitch), type: MC 1.5/5-ST-3.5.
®
Pin nr. Signal
1 Left +
2 Left -
1 2 3 4 5
3 Ground
4 Right -
5 Right +
See more information about the most common audio cable wiring
modes in Audio Cable Wiring Guide section.
3.3.3. RS-232 Port
The 3-pole Phoenix connector is used for the local RS-232 serial
connection.
Pin nr. Signal
1 Ground
2 Tx data
1 2 3
3 Rx data
Compatible Plug Type
Phoenix Combicon series (3.5mm pitch, 3-pole), type: MC 1.5/3-ST-3.5.
®
See more information about the most common serial data cable wiring
modes in Cable Wiring Guide for Serial Data Transmission
3.3.4. Ethernet (LAN) Port
The matrix provides standard RJ45 connectors for TPS input and
output ports.
8 1
RJ45 connector for LAN port
Wiring of TPS and LAN Cables
Lightware recommends the termination of LAN cables on the basis of
TIA/EIA T 568 A or TIA/EIA T 568 B standards.
8
1
Top
Pin TIA/EIA T568 A Color and name
1 white/green stripe
2 green solid
3 white/orange stripe
4 blue solid
5 white/blue stripe
6 orange solid
7 white/brown stripe
8 brown solid
When a standard Ethernet device is connected to the TPS connector
for some reason, the port is switched to Ethernet fallback mode
automatically.
section.
MMX6x2-HT series – User's Manual
1 8
RJ45 connector for TPS input port
1
8
Bottom Side
TIA/EIA T568 B Color and name
white/orange stripe
orange solid
white/green stripe
blue solid
white/blue stripe
green solid
white/brown stripe
brown solid
3.3.5. LAN and TPS Ethernet Port
The matrix contains two RJ-45 connectors for Ethernet/LAN
connection: one for local control functions and one for the TPS lines.
The two interfaces are connected (default) but can be separated. The
connector with LAN display is for local controlling functions – the
matrix can be configured and controlled via local Ethernet via this
port. The connector with TPS Ethernet display is to supply the Ethernet
to the TPS ports.
The Ethernet ports can be connected to a LAN hub, switch or router
by a CATx cable. However both cable types (straight or cross) are
supported and handled by the device, below pin assignment is
recommended.
Pin Name Color and name
TX + white/green stripe
1
TX - green solid
2
3 RX + white/orange stripe
4 Not used blue solid
5 Not used white/blue stripe
RX - orange solid
6
Not used white/brown stripe
7
8 Not used brown solid
off
LED1 green
on
off
8 1
LED2 amber on
blinking activity
13
0 Mbit/s
100 Mbit/s
not linked
no activity