Microphone Input Channel; Legend Of Microphone Input Channel - Lightware MMX8x4-HT Series User Manual


  
5. Software Control – Lightware Device Controller
5.7.7. Microphone Input Channel
t
1
r
e
w
5.7.8. Legend of Microphone Input Channel
3 4
2
1
Channel name
5
Phantom power
2
button
6
ATTENTION! Application of the phantom power can cause a damage if
dynamic or wireless microphone is connected!
7
Phase invert
3
button
Feedback button
4
Preset Button
5
Gain section
6
8
HPF button
7
LPF button
9
q
MMX8x4-HT series – User's Manual
Displays the channel name. All the settings below
belongs to the channel.
Keep pressed the button for more then 2 sec to switch
on and off the 48V DC. It gives remote powering via
the microphone cable to the condenser microphones.
It inverts the phase of the input signal.
Turning on this feature hides the Feedback
phenomenon. Before applying this button, check if
gain or the volume could be decreased.
Clicking on this button opens a Mic Input Channel
Preset window. For more details see Channel Presets
section.
GAIN setting is for increase (or decrease) the input
microphone signal level, expressed in dB.
For more information see Gain Settings.
High-pass filter lets pass the microphone signals
above 100Hz frequency. Click on the button to toggle
turn it on and off.
Low-pass filter lets pass the microphone signals under
15kHz frequency. Click on the button to toggle turn it
on and off.
EQ section: The equalizer section is for set the proper rate
8
HIGH, HMID, of the different frequencies (high: 12kHz; high-
LMID, LOW mid: 1.6 kHz, low-mid: 400Hz, low: 120Hz).
For more details, see Equalization (EQ)
Mic preset Five factory presets are available for microphone input
9
channel. These are specialized for the most common
microphone types. For more details see
presets section.
Factory defaults Restore the factory default settings on te microphone
q
button channel. For more details see
Settings.
Input volume Sets the volume of the input microphone signal
w
fader between -80dB and +10dB. It also can be controlled
by scrolling or writing the value in the text field.
Signal indicator This section gives a feedback about the actual level
e
chart of the input signal. See more details in
Balance Settings section.
Mute/Unmute Mutes/unmutes the microphone input.
r
Panorama This setting defines, that the balanced microphone
t
section input is transmitted to the left or right channel of
the balanced analog output. For more details, see
Panorama or Balance Settings.
ATTENTION! Not proper setting could damage the device!
See more details about connect the microphone in
for Connecting a Microphone section.
48
Settings.
Factory MIC
Factory Default
Panorama or
Installation Guide