Table of Contents
Advertisement
5. Software Control – Lightware Device Controller
6.7.7. Microphone Input Channel
t
1
r
e
w
3
4
2
5
6
7
8
9
q
MMX8x4-HT series – User's Manual
6.7.8. Legend of Microphone Input Channel
1
Channel name
Phantom power
2
button
ATTENTION! Application of the phantom power can cause a damage if dynamic or wireless microphone is
connected!
Phase invert
3
button
Feedback button
4
Preset Button
5
Gain section
6
HPF button
7
LPF button
EQ section:
8
HIGH, HMID,
LMID, LOW
Mic preset
9
Factory defaults
q
button
Input volume
w
fader
Signal indicator
e
chart
Mute/Unmute
r
Panorama
t
section
ATTENTION! Not proper setting could damage the device! See more details about connect the microphone in
Installation Guide for Connecting a Microphone
Applied firmware package: v1.2.2b5 | LDC software: v2.2.1
Displays the channel name. All the settings below belongs to the channel.
Keep pressed the button for more then 2 sec to switch on and off the 48V DC. It gives
remote powering via the microphone cable to the condenser microphones.
##analogaudio #balance volume #advancedaudio #mic #microphone
It inverts the phase of the input signal.
Turning on this feature hides the Feedback phenomenon. Before applying this button, check
if gain or the volume could be decreased.
Clicking on this button opens a Mic Input Channel Preset window. For more details see
Presets
section.
GAIN setting is for increase (or decrease) the input microphone signal level, expressed in dB.
For more information see
Gain
Settings.
High-pass filter lets pass the microphone signals above 100Hz frequency. Click on the button
to toggle turn it on and off.
Low-pass filter lets pass the microphone signals under 15kHz frequency. Click on the button
to toggle turn it on and off.
The
equalizer
section
is
for
frequencies
(high:
12kHz;
high-mid:
For more details, see
Equalization (EQ)
Settings.
Five factory presets are available for microphone input channel. These are specialized for the
most common microphone types. For more details see
Restore the factory default settings on te microphone channel. For more details see
Default Settings.
Sets the volume of the input microphone signal between -80dB and +10dB. It also can be
controlled by scrolling or writing the value in the text field.
This section gives a feedback about the actual level of the input signal. See more details in
Panorama or Balance Settings
section.
Mutes/unmutes the microphone input.
This setting defines, that the balanced microphone input is transmitted to the left or right
channel of the balanced analog output. For more details, see
section.
66
Channel
set
the
proper
rate
of
the
different
1.6
kHz,
low-mid:
400Hz,
low:
120Hz).
Factory MIC presets
section.
Factory
Panorama or Balance
Settings.
Advertisement
Table of Contents
Troubleshooting
