How Do I Set And Add An Electricity Meter - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
2.
3.
----End

8.7.17 How Do I Set and Add an Electricity Meter?

Prerequisites
●
●
●
Issue 04 (2021-10-09)
Add an ATS.
Table 8-16 Adding an ATS
Path Parameter
Choose Device
System attribute
Settings >
Device Type
Device
Management
Connect To
and click Add
Device. The
parameters
Communicati
for adding
ons Port
devices are
displayed.
Device
Address
Click Test Connect to check whether the ATS is properly connected to the
ECC800-Pro.
– If the connection succeeds, click Confirm. The connected devices are
displayed in the Number of connected devices list.
– If the connection fails, check whether the device is properly connected to
the ECC800-Pro, whether the device and ECC800-Pro are running
properly, and whether the parameter settings are consistent with the
device parameters.
The RS485 communications cable of the electricity meter is correctly
connected.
The electricity meter is working properly.
Communications parameters have been correctly set for the electricity meter.
If the communications parameters of the electricity meter cannot be set
based on the recommended values in the following table, modify the
communications parameters for the COM port on the ECC, UIM, or ETH
converter that connects to the electricity meter to ensure that the parameters
are consistent with the communications parameters of the electricity meter.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select ATS from the drop-down list box.
Select ATS from the drop-down list box.
Select ECC800 from the drop-down list
box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the ATS is
connected to the COM1 port on the ECC800-
Pro. If the ATS is connected to another port,
select the number of the connected port.
In this example, Device Address is set to 1.
During actual configuration, set the device
address for the ATS based on the actual
situation.
8 FAQ
323