Yamabiko ECHO Robotics Turfmow 1000 Technician Manual page 76

Chapter 7 Installation
10. Edit the values if necessary, then highlight
11. The wizard will then ask you on which side of the robot the charging station is located.
Press the Left or the Right button accordingly the press
12. The wizard will then ask "Do you need to define a start zone?" If you don't define a start
zone, the robot just follows the wire, then does the loopstep, then starts mowing. If you
answer YES, the screen will then display the proposed parameters for following the track
border after the trackwire movement.
Max.Distance
13. Edit the values if necessary then highlight
14. You will now see the message "The Mower will attempt to reach its initial position".
Highlight
The robot will now perform a number of manoeuvres to return to its starting point.
76 Turfmow 1000 Technician's Manual
Figure 72: Minimum and Maximum distances
for the trackwire movement leaving the station
and
Min.Distance
Figure 73: Start zone parameters determined by the wizard
and close the lid.
Next
Note: It will NOT use the distance parameters set for leaving the station during
these manoeuvres.
and press
Confirm
are illustrated in the figure below.
and press
Confirm
Version: Release 3.5
.
.
Last updated: 2018-12-20