Yamabiko ECHO Robotics Turfmow 1000 Technician Manual page 113

Enable pin code
Highlight the check box. Press
Enable PIN code OFF
Enable PIN code ON
Press
From now on certain commands will require the PIN code to be entered before they can
be executed.
Change pin code
Allows you to change the pin code.
Enter the required numbers and press
Geofence
A Geofence is a circular security zone in which the robot is allowed to operate. If the robot
moves out of this area, a security notification will be issued. The circular area is defined by its
center and a radius.
Note: This functionality is not fully supported in the current version.
The current location of the center point can be viewed in the
110).
To define and implement a security zone
1. Move the robot to the required center of the security zone.
2.
Press
3.
Press use the arrow keys to highlight
4.
Press the arrow keys to highlight
5. Highlight
The latitude and longitude of the current position are displayed.
6.
Use
7.
Make sure this option is checked on. Use
Turfmow 1000 Technician's Manual
to accept the new setting.
.
.
Define current position
to highlight
Enable Geofence
Version: Release 3.5
to toggle the setting.
.
, then press
Security
and press
Geofence
.
to toggle the setting.
Chapter 8 Using your robot
device settings menu (page
.
.
Last updated: 2018-12-20 113