Table of Contents
Advertisement
The cutting blades need to be replaced on a regular basis to ensure optimal mowing
performance.
The height of the cutting head determines the length of grass that is cut. This can be
adapted to match the required conditions. See
(9) Battery
An LFP battery powers Turfmow 1000 whilst mowing. When the battery needs charging
the robot will return to the charging station. See
25).
Information on the labels on the battery are given in
(10) Sealed Electronic box
This contains the electronics and the robot motor.
(11) Coil
The robot is equipped with a coil that detects the magnetic field generated by the
peripheral wire. When the robot crosses the peripheral wire, it registers a change in
phase of the signal in the wire, which indicates it is leaving the field. As a consequence it
will change direction in order to return into the field. See
(12) On/Off switch
Switches the robot on or off.
Identification labels
There are two identification labels providing information about the individual robot.
The identification label can be found on the inside of the Stop button lid as shown below.
A second one, which contains identical information is situated on the sealed electronic
box (component 10 in
not normally visible. This ensures that whenever the robot is dismantled, for whatever
reason, the body and smart box containing the interface are correctly matched with the
mechanical components.
Turfmow 1000 Technician's Manual
Note: This should only be opened or manipulated by an authorized technician.
Figure 5: Identification label under the Stop lid.
Figure 3: Bottom view of robot components
Figure 6: Identification label on the chassis
Version: Release 3.5
setting the cutting height
Go to charging station mode
Notices
(page 192).
Work mode
(page 23).
(page 12)) and is
Last updated: 2018-12-20
Chapter 4 Turfmow 1000 description
(page 105).
(page
13
Advertisement
Table of Contents
