Table of Contents
Advertisement
Chapter 11 Service and Maintenance
5.
Lift the body off.
6.
Clean away the mud and the grass using the brush and/or a spatula such as the ones
shown below. If compressed air is available this is more effective.
When the service is complete:
1.
Replace body onto the chassis.
2.
Tighten the 4 bolts to a torque of 7Nm.
3.
Re-connect the cables.
Inspect the bumper
1.
Check that the bumper material is intact; no cuts or tears. If so
2.
Clean the bumper with a damp cloth.
Note: Do NOT use water.
Inspect and clean the sonar sensors
The sonar sensors need to be kept clean if they are to operate properly. All need to work
properly otherwise an alarm is issued.
1.
Remove any mud, grass or dirt and wipe with a cloth.
170
Turfmow 1000 Technician's Manual
Note: Do NOT use water.
Version: Release 3.5
replace it
(page 189).
Last updated: 2018-12-20
Advertisement
Table of Contents
