Yamabiko ECHO Robotics Turfmow 1000 Technician Manual page 164

Chapter 11 Service and Maintenance
- Check the wiring
- Replace the cutting blades
At the end of the season
- Battery
- Wintering
Regular cleaning (during wet weather)
During periods of wet weather it is necessary to ensure that mud and grass do not
accumulate on the moving parts: the wheels and the cutting heads. These should be
inspected and cleaned daily.
1. Hit the red button to stop the robot.
2. Turn the machine onto its rear side.
3. Switch the machine OFF.
4. Remove any accumulations of grass and dirt using a wire brush and/or a spatula.
5. Rub the body with a soft, damp cloth or sponge.
6. If the body is very dirty, use a soapy solution or washing-up liquid. Never use solvents!
Clean the charge contacts
This procedure should be performed weekly on both the robot and the charging station.
Rub the contact surfaces with grade 280 sandpaper until they appear clean.
Clean the bumper
This procedure should be performed weekly.
Check that the bumper material is intact; no cuts or tears. If it is contact an authorized
technician.
Clean the bumper with a damp cloth.
Note: Do NOT use water.
Clean the sonar sensors
This procedure should be performed weekly.
164 Turfmow 1000 Technician's Manual
(page 167).
(page 166)
(page 167).
(page 168)
Charge contacts on the robot Charge contacts on the station
Version: Release 3.5 Last updated: 2018-12-20