Yamabiko ECHO Robotics Turfmow 1000 Technician Manual page 167

Undo the screw to remove the blade.
Note: Use a flat-headed screw driver with a blade width of 8mm and a thickness of
1.2mm.
Position the new blade and tighten the screw.
Note: After any intervention on the cutting heads:
- Rotate each of them independently.
- Check that each one does not cause any of the other heads to rotate.
Clean the rear wheels
This procedure should be performed weekly. (Daily in periods of wet weather.)
Remove any mud and grass using a wire brush.
If wheel brushes are installed, these will keep the wheels clean, but the brushes should be
inspected and cleaned.
Check the wiring
This procedure should be performed every six months.
Visually inspect the wiring under the robot. If any problems are detected, contact an
authorized technician.
Battery
Turfmow 1000 robotic mowers are equipped with the latest generation LFP batteries.
Note: In the event of leakage of electrolyte, flush with water and seek medical help if it
comes in contact with the eyes etc.
The automatic (programmed) operation of the robot optimizes battery life. It is advisable to
allow the robot to manage its working cycles. If these work cycles seem unusually short,
contact an authorized technician to check the condition of the battery.
Note: It is possible to monitor these cycles using the portal.
Turfmow 1000 Technician's Manual Version: Release 3.5
Chapter 11 Service and Maintenance
Last updated: 2018-12-20 167