Yamabiko ECHO Robotics Turfmow 1000 Technician Manual page 177

9. Add some glue to hold the washer on the threaded axle.
10. Replace the hexagonal washer. Tighten it to 20Nm.
11. Set the screw in the axle.
12. Place the disc assembly back onto the cutting head axle. Make sure that the screw
shown above touches the flat surface of the cutting head axle as shown below.
Turfmow 1000 Technician's Manual Version: Release 3.5
Chapter 11 Service and Maintenance
Last updated: 2018-12-20 177