Table of Contents
Advertisement
Chapter 11 Service and Maintenance
13. Tighten the screw onto the axle using 6Nm.
Wiring cutting disk
1.
Visually inspect the wiring for the cutting discs.
2.
Repair any damage to the sheathing with tape.
3.
Replace clips if necessary.
4.
Replace the cable
Cutting motor
1.
Undo the 6 screws shown below (3 on the motor casing, and 3 on the bracket).
2.
Remove the bracket.
3.
Loosen the nut on the cable connection and lift the lid.
4.
Remove the green gasket.
178
Turfmow 1000 Technician's Manual
(page 189) if damaged.
Version: Release 3.5
Last updated: 2018-12-20
Advertisement
Table of Contents
