Table of Contents
Advertisement
4.
Verify that all the LEDs indicate that there is no power connected.
5.
The board must be located on the three supports shown in
the positioning signal board
6.
Connect the power cable to the wire board. Ensure the wire is properly screwed and
secured.
7.
Take the cable behind the wire and positioning boards and push the other end into the
socket on the positioning board.
Turfmow 1000 Technician's Manual
(page 63).
Note: One of these should be a metal grounded support. See
positioning board supports
Version: Release 3.5
(page 69).
Chapter 7 Installation
Figure 66: Components on
Upgrade the
Last updated: 2018-12-20
65
Advertisement
Table of Contents
