Table of Contents
Advertisement
5.
Un-clip the electrical connections.
6.
Visually inspect the interior of the motor. Check for dampness and dry it out if necessary.
7.
Visually inspect the electronic board.
8.
Re-connect the electrical connections.
9.
Place the new green gasket in position.
10. Place the lid back in position.
11. Replace the bracket.
12. Screw the 6 screws in place. Use a torque of 1.5Nm.
13. Tighten the nut around the cable connection.
Cutting height system
1.
Visually inspect all the straps.
2.
Rotate the shaft by hand and check that the cutting heads move up and down smoothly.
Wiring cutting disk
1.
Visually inspect the wiring for the cutting discs.
Turfmow 1000 Technician's Manual
Version: Release 3.5
Chapter 11 Service and Maintenance
Last updated: 2018-12-20
179
Advertisement
Table of Contents
